How to do if the motor breaks the shaft? Reduction motor broken shaft fault processing method!
1. Due to low temperature or other reasons, the fluidity of lubricating oil inside the reducer becomes worse, and the instantaneous current of the motor rises, resulting in overload protection of the driver. Start several times.
(2) If the gear inside the reduction motor is worn and cut, it is necessary to disassemble and clean or replace the internal gear.
2. The internal planetary frame is shifted, and the friction of the internal gear produces iron cutting. At this time, the reducer needs to be replaced.
3. The bearing at the output end is displaced, deformed or worn. At this time, it is necessary to replace the bearing with the replacement and dismantling machine and check whether the internal gear is worn or cracked.
4. This is a common situation, mostly caused by too much lubricating oil, until the excess oil is consumed, it will not appear this situation.
5.① If deceleration is overloaded for a long time, the output shaft will be partially fractured due to fatigue. Running according to the specified requirements of the manufacturer can minimize the occurrence of such accidents.
(2) The force on the output shaft is not uniform, the radial load exceeds the rated range, or it works at the rated maximum strength for a long time.